4. CONFIGURATIONS

The following information on roll-cages, outriggers, mountings, seat-belts etc. represents minimum specifications which may be added to as required.

4.1. (Drawing)

4.2. These two plan-view drawings show:-

4.2.1. Alternative types of tube connecting the main hoop to the front hoop. Straight or bent ones may be used subject to the limits shown on the next page.

4.2.2. Alternative positions for the rear braces where they join the main hoop. Any area between the two positions shown may be used.

4.2.3. Alternative positions for centre-bar or diagonal which is required for open vehicles only. If two or more centre bars are fitted, they should be evenly spaced.

4.3.(Drawing)

4.4.  The feet spacing 'a' to 'c' should be as far apart as possible within the load area. The smaller the angle abc at the top, the less effective are the bracing bars.

4.5.  Read on for methods of attachment to chassis.

Go back to 3, or on to 5

Last Updated:
18/02/2007